| 引用本文: | 秦砺寒,陈 丹,李顺昕,等.面向配电网可靠性评估的输电网等值方法[J].电力系统保护与控制,2016,44(22):71-76.[点击复制] |
| QIN Lihan,CHEN Dan,LI Shunxin,et al.An equivalent method of transmission system for distribution network reliability assessment[J].Power System Protection and Control,2016,44(22):71-76[点击复制] |
|
| 本文已被：浏览 4726次 下载 1800次 |
码上扫一扫！ |
| 面向配电网可靠性评估的输电网等值方法 |
| 秦砺寒,陈丹,李顺昕,赵国梁,曹天植,黄江倩 |
|
|
(国网冀北电力有限公司经济技术研究院, 北京 100045;华北电力科学研究院有限责任公司, 北京 100045
;.浙江大学电气工程学院, 浙江 杭州 310027) |
|
| 摘要: |
| 随着主动式配电网的发展和分布式能源的大量接入，输电网与配电网间的联系日益复杂紧密，在对配电网进行可靠性评估时应充分考虑输电网可靠程度。提出了一种量化输电网可靠程度的输电网等值方法，用以提高配电网可靠性评估的实用性。首先，提出了节点最大负载能力的概念，用以表征输电网向下游配电网的最大供电能力，进而将输电网等值成配电网的电源节点。其次，采用蒙特卡洛模拟法和最优化技术相结合的方法，建立了输电网节点最大负载能力计算评估模型。最后，采用RBTS输电系统进行测试，验证了所提出的输电网可靠性量化等值方法的有效性。 |
| 关键词: 可靠性评估 最大负载能力 蒙特卡洛模拟法 最优化技术 |
| DOI：10.7667/PSPC152006 |
| 投稿时间：2015-11-16修订日期：2016-06-14 |
| 基金项目:国网科技项目“基于分布式光伏接入主动消纳的冀北配电网规划” |
|
| An equivalent method of transmission system for distribution network reliability assessment |
| QIN Lihan,CHEN Dan,LI Shunxin,ZHAO Guoliang,CAO Tianzhi,HUANG Jiangqian |
(State Grid Jibei Electric Power Company Limited Economic Research Institute, Beijing 100045, China
;North China Electric Power Research Institute Company Limited, Beijing 100045, China
;College of Electrical Engineering, Zhejiang University, Hangzhou 310027, China) |
| Abstract: |
| With the development of the active distribution network and the distributed energy, the links between the transmission grid and distribution network are more and more close and complex. The reliability of the transmission grid should be fully considered when the distribution network reliability assessment is studied. This paper presents a method to quantify the reliability of the transmission grid, in order to enhance the practicability of the reliability assessment of the distribution network. First, this paper presents the concept of maximum load capacity that shows the maximum power supply capacity of the transmission grid to supply the downstream distribution network, and then the transmission system can be equivalent to the power supply node of the distribution network. Secondly, Monte Carlo simulation and optimization techniques are used to establish the maximum load capacity evaluation model. Finally, RBTS transmission test system is used to verify the effectiveness of the proposed method of quantifying the reliability of the transmission grid. |
| Key words: reliability assessment maximum load capacity Monte Carlo simulation optimization techniques |
